How to Switch Boom Direction (Basic/E or Basic/E2 Controller)

Public Channel / Guide

How to switch your boom's movement direction if it has an original Basic/E controller or the Basic/E 2 controller.

Share on Social Networks

Share Link

Use permanent link to share in social media

Share with a friend

Please login to send this document by email!

Embed in your website

Select page to start with

Post comment with email address (confirmation of email is required in order to publish comment on website) or please login to post comment

1. A H A A H Forward Forward SWITCH BOOM DIRECTION (Basic/E Controller) We want to change the direction of the whole boom from this, to this:

4. X X Then this is your 'Away' reader If this is forward: Boom Put a magnet on the rail and point it toward your away reader: Your screen should show: SWITCH: -2-4-- X X This is your 'Home' reader If this is forward: Put a magnet on the rail and point it toward your home reader: Now your screen should show: SWITCH: --34-- If they're reversed, flip them. If you see other numbers (besides '1' being there the whole time), or have any questions at all, call GTI: Main Office Line (8am-4:30pm Weekdays) Emergency Tech Support Line (24hr - please call Main office line on workdays) (888) 827 - 5204 (859) 358 - 9595

3. (3) Double Check A good way to check if your motor and sensors are matching up is to check the sensors in Test mode. Mode:Test C Mode SWITCH: ---4-- VALVES: ------ You may need to press the mode key a few times until you see this screen: Then press Run And then press the up key 6 times until you see this screen: The '4' is always there (or should be). It's the collision input. Also, '1' might or might not be showing; it's the motion reader input. It is on or off depending on how the idler axle is rotated.

2. MTR - MTR + Motor Out Transformer White Black MTR - MTR + Motor Out To the Motor (or Junction Box) White Black MTR - MTR + Motor Out To the Motor (or Junction Box) Switch the motor '+' and '-' leads: and swap them Take These (1) SWAP THE MOTOR LEADS Sensors Home Reader Away Reader Sensors This was the Home Reader, now it's the Away Reader! JB REV JB FWD JB REV JB FWD RTN RTN INDEX START COLLISN JB REV JB FWD MOTION Sensors Transformer Swap the 'JB FWD' and 'JB REV' wires, like this: This was the Away Reader, now it's the Home Reader! (2) SWITCH THE MAGNET READER WIRES

Views

  • 37 Total Views
  • 24 Website Views
  • 13 Embeded Views

Actions

  • 0 Social Shares
  • 0 Likes
  • 0 Dislikes
  • 0 Comments

Share count

  • 0 Facebook
  • 0 Twitter
  • 0 LinkedIn
  • 0 Google+